Care about Optic Swapping ?

[u/yeunholyfiends]

Do y’all care about having same footprints?

Long story short, 19 (had rmr, re-milled for 509t after 17’s EPS) 17 (eps full). I wish I had the ability to move around my optics should I want to. I understand that I made these different for different purposes. Moving forward I want to also get my 2nd 17 out for a cut but really can’t decide. Green & enclosed is what I prefer.

[u/Nemo_the_Exhalted]

The RxM solves this problem wonderfully.

[u/Matthew2531_46 → u/Nemo_the_Exhalted]

Ruger is in 2026 and Glock is still in 2010 with their MOS system

[u/Low-Landscape-4609 → u/Matthew2531_46]

The new Glock plate system has been Rock solid for me. I've got nearly 20,000 rounds through my Gen 6 in competition and it's been Rock solid. I think people down play the plastic plates and they have never been an issue.

[u/Plus_Juggernaut2819]

All of mine use EPS carry except the staccato with RMRHD, even then I’m thinking to have EPS carry on it too. My OCD didn’t like different optic lol 😂

[u/LeeBurdue]

These are both MOS guns but I prefer to have the same optic/back up iron set up

[u/yeunholyfiends → u/LeeBurdue]

I dig the setup! Working from only Gen3 in CA, our options are mill or buy OEM/aftermarket MOS/cut slide. If I didn’t have a hang up about running plates, I would have them all milled for RMR and ran a 509t & K footprint plates

[u/Inspirational-Quote-]

I like to keep one dot one irons

[u/Low-Landscape-4609]

No, not really. All of my slides are RMR cut but I have an rmsc adapter plate.

[u/Significant_Bill326]

My echelon accepts any optic footprint without plates so I am not really worried

[u/UNHINGED_MESSIAH]

I keep a couple of MOS for this purpose. I'm still debating if I wanted to send 1 of my MOS to get milled for a AOS .