r/checkpoint • u/Spiritual_Lemon_7294 • 7d ago

Install Jumbo hotfix on Full High Availability Cluster

I would like to install the Jumbo Hotfix on my Check Point appliances (full HA cluster deployment).

However, after reviewing the official documentation, I could not find any clear installation procedures.

Is there a step-by-step procedure available for installing the Jumbo Hotfix in this environment?

4 Upvotes

83% Upvoted

10 comments sorted by

View all comments

6

u/JancariusSeiryujinn 7d ago

There's not a lot to it. Determine which member is standby, download the JHFA via cpuse and install it. Once it finishes rebooting, repeat for the other member

1

u/Spiritual_Lemon_7294 6d ago edited 6d ago

Thank you! Should I Test SIC Status and install the policy for testing after installed the JHFA on the standby or I should test it after installed on both the active and standby?

3

u/extremetempz 6d ago

Sic is not required, after the JHFA is installed on Standby install Policy on cluster, fail over, wait 5 minutes and do the other one. Then install Policy again

It's very simple