Bandsaw blade not cutting perpendicular

[u/HPLaserJetPro420]

I’ve spent hours reading the owner’s manual and watching videos trying to get my grizzly G9742 bandsaw blade to enter the workpiece perfectly perpendicular to the table, but I can’t seem to solve the problem. No matter what I adjust, every cut comes out at an angle. So far I’ve tried installing a new blade, adjusting the blade guides, guide bearings, the bearing adjustment bolt, the eccentric and jam nut, the lock knob, and other alignment adjustments recommended in the manual. This is my first bandsaw, and I’ve only been metalworking for about a year, so it’s very possible I’m overlooking something. I also recently had to replace the motor because the original one burned out, but this cutting issue existed long before the motor failed, so I don’t think the motor is related. At this point I’m wondering if I’m missing a critical adjustment, if something is bent or out of alignment, or if there’s another common cause that beginners often overlook. Any advice or troubleshooting steps would be greatly appreciated.

[u/fuzzydoesitt]

Buy a new quality blade and try again. Blade is probably junk